Additive Layer Manufacturing for Aerospace Parts Essay

ES Technology has revealed that additive layer manufacturing (ALM) for direct part production has been embraced by a number of manufacturing sectors, not least the aerospace intentness The ability to produce components in a range of materials including hot-work steels, stainless steel, cobalt chromes and Inconel, plus titanium and aluminum alloys, presents the aerospace industry with large electromotive force for direct part production using ALM. ALM has already been used to produce small and medium- surfaced aerospace components, and having realised the potential of the process, aerospace manufacturers are pursuit to produce larger, more complex parts. Material Solutions operates an ALM applications development centre with a particular focus on the aerospace sector.Carl Brancher of Material Solutions, said ALM in high-performance materials is swell suited for complex thin-walled structures in gas turbines. However, as a new technology it is not yet well understood or validated b y potential users and, like all manufacturing processes, to get the best from metal ALM requires the designer to understand the process capabilities and materials mechanical properties, he added. Brancher said Materials Solutions is bridging this gap by providing make parts, consulting (principally to the aerospace market), and working with equipment and materials vendors to develop the technology for mass production.See moreMasters of Satire John Dryden and Jonathan Swift EssayThe collaboration between Material Solutions and its industry clients has so far led to the production of a range of components over the last three years. This programme has now reached the limit of component sizing that tolerate be produced using the existing Material Solutions ALM systems. With the continuing pressure from aerospace manufacturers to develop the capability to produce larger parts, Material Solutions turned to Concept Laser to look the potential for building larger components using Concept Lasers M3 bilinear system. The fundamental principles of the M3 linear make it a novel development in the world of ALM.Unlike other machines the M3 linear does not have fixed optics but a combination of galvo scan mirrors and linear direct drives to move the scanning head. Already used to build larger volume components, the M3 linear has all of the pre-requisites for up-scaling to enable production of the types of components envisaged by the aerospace industry. It is not only the physical attributes of the system that leave themselves to production of large components but the process control and laser scanning strategy already developed by Concept Laser, which will eliminate the potential pitfalls of accuracy errors on large components.Having established the potential of the M3 linear machine, Material Solutions set out to design a test component that would qualify indisputable build criteria and which could also be used to educate and inform aerospace designers of Additive Frie ndly design features and techniques. These include reducing supports and using larger flowing radii to care in reducing the time to build and subsequently, component production and finishing costs. The test part incorporates many features such as small diameter holes, wind features, thin rib sections and areas of thick material section all typically found in aerospace components.The greatest challenges for Concept Laser were that a component of this size had never before been build and added to this the part was required in an unexpectedly short timescale. The finished component demonstrates the current capabilities of the technology in terms of size (300mm diameter), accuracy and surface finish. While this part does not yet satisfy the ultimate demands of aerospace manufacturers it clearly confirms the capabilities of the process, the scalable potential of Concept Lasers M3 linear machine and the sound base which Concept Laser have for further development of the M3 linear for la rge aerospace components.There are also practical aspects to be considered when building large parts. Larger volume components require greater volumes of powder and hence a robust and stable platform to accommodate the weight. Having then built a large volume, and potentially very heavy component, safe and easy removal is essential.The M3 linear machine is built around a substantial sham framework and already incorporates a removable build module enabling the module and component to be easily positioned under an overhead crane if required. The triumph of this exercise and the current collaboration between Material Solutions and Concept Laser will be used to define the future strategies that will eventually jut parts manufactured by ALM techniques leave the laboratory and take to the air.